CROSSMEMBER, Front Fore And Aft: Installation: Installation

WARNING: This page is about a different car, the 2014 Jeep Patriot and 2014 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Fore/Aft Crossmember 2

Courtesy of CHRYSLER GROUP, LLC

Install the fore/aft crossmember and install the engine anti-roll mount (3) through bolt (2).

Fig 2: Fore/Aft Crossmember 1
Courtesy of CHRYSLER GROUP, LLC
Install the bolts (1, 2 and 3), and tighten using the following sequence:
1. Tighten the bolt (1) to 78 N.m (58 ft. lbs.).
2. Tighten the bolt (2) to 78 N.m (58 ft. lbs.).
3. Tighten the bolt (3) to 129 N.m (95 ft. lbs.).
Fig 3: Fore/Aft Crossmember 2
Courtesy of CHRYSLER GROUP, LLC
Tighten the bolt (2) to 65 N.m (48 ft. lbs.).

Fig 4: Belly Pan
Courtesy of CHRYSLER GROUP, LLC
If equipped, install the belly pan.
Install the three front screws (4), the three rear screws (2) and on push pin fastener into the center of the belly pan.