LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2017 >> Renegade Trailhawk >> Repair and Diagnosis >> External Pages >> Different car >> Section 246 (Fuel System) >> Fuel Delivery, Diesel >> Module, Fuel Pump >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Module, Fuel Pump: Installation

WARNING: This page is about a different car, the 2017 RAM ProMaster 3500, 2017 RAM ProMaster 2500, and 2017 RAM ProMaster 1500. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:

Whenever the fuel pump module is serviced, the rubber O-ring seal must be replaced.

  1. Using a new O-ring seal (gasket), position fuel pump module (9) into opening in fuel tank.
  2. Position lock ring (8) over top of fuel pump module.
  3. Install Lock ring Remover/Installer Tool (special tool #9340, SAE Fuel Pump Lock Ring Wrench) to lock ring.
  4. Install 1/2 inch drive breaker into Lock ring Remover/Installer (special tool #9340, SAE Fuel Pump Lock Ring Wrench).
  5. Tighten lock ring (clockwise) until all notches have engaged.
    GC0162111Courtesy of CHRYSLER GROUP, LLC
  6. Connect the return line (3).
  7. Connect the supply line (1).
  8. Connect the vent line (2).
  9. Connect the fuel pump module wire harness connector (4).
    GC0161942Courtesy of CHRYSLER GROUP, LLC
  10. Install the fuel pump module cover (2) and securely tighten screws (1).
    GC0162138Courtesy of CHRYSLER GROUP, LLC
  11. Install the cover (3) and securely tighten fasteners (1, 2).
  12. Connect the negative battery cable.
scientia non olet · About LEMON Manuals