Sensor, Particulate Matter: Installation
WARNING: This page is about a different car, the 2017 RAM ProMaster 3500, 2017 RAM ProMaster 2500, and 2017 RAM ProMaster 1500. However, it is still accessible from the selected car via links, so may be relevant.
- Install the Particulate Matter (PM) sensor (1). Tighten sensor to 50 N.m (37 ft. lbs.).
- Route the wire harness and install the exhaust heat shield retainers (2).
- Install the PM sensor module (1). Tighten nuts (3) to 9 N.m (80 in. lbs.).
- Connect the PM sensor module wire harness into retainer (2).
- Connect the PM sensor wire harness connector (4).
- Remove support and lower the vehicle.
- Connect the negative battery cable.