LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2018 >> Compass Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 108 (Antilock Brake System (Abs) - Abs Verification Test, Abs Intermittent Condition And EPB Verification Test) >> Standard Procedure >> EPB Verification Test
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

EPB Verification Test

WARNING: This page is about a different car, the 2019 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.

EPB VERIFICATION TEST 

  1. Turn the ignition off.
  2. Remove all test equipment.
  3. Connect all previously disconnected components and connectors.
  4. Verify all accessories are turned off and the battery is fully charged.
  5. Verify that the ignition is on. With the scan tool, record and erase ABS DTC. Start the engine and allow it to run for two minutes.
  6. Cycle the ignition from off to on.
  7. Pull the EPB Switch to apply the Electric Parking Brakes.
  8. Press and hold the brake pedal.
  9. Push the Electric Park Brake (EPB) Switch to release the Electric Parking Brakes.
  10. Release the brake pedal.
  11. Cycle the ignition from off to on.
  12. Turn the ignition off and wait ten seconds. Turn the ignition on and using the scan tool, read the DTCs from all modules.
  13. If any DTCs are present, refer to DTC INDEX for the Diagnostic procedure and troubleshoot the new or recurring symptom.
  14. If there are no DTCs present and the customer's concern can no longer be duplicated, the repair is complete.

    Are any DTCs present or is the original concern still present?

    Yes 

    No 

    • Repair is complete.
scientia non olet · About LEMON Manuals