Fan, Cooling: Installation: 6.2L
- Install the upper shroud cover (1). Apply pressure downwards until the cover snaps into place past clips (2).
- Install cooling fan assembly into vehicle.
- Guide the fan/shroud cover assembly into position between the radiator and upper core support.
- Position cooling fan assembly onto the mounts (3) located on the radiator.
- Lock in the fan (1) assembly into place by pressing down firmly on the shroud till the locks (3) engage.
- Connect electric fan electrical connector (2).
- Raise and support the vehicle.
- Install the lower cooling shroud cover by applying upwards pressure till the cover snaps into place onto the cooling fan shroud.
- If equipped, install the lower engine cover.
- Lower vehicle.
- Connect the front section of the A/C liquid line (3) to the rear section of the A/C liquid line (1).
- Install the nut (2) that secures the two sections of the A/C liquid line together. Tighten the nut to the proper specification. Refer to LINE, A/C LIQUID, INSTALLATION
.
- Install the bolt (2) that secures the A/C liquid line support bracket (3) to the upper radiator support (1). Tighten the bolt securely.
- Evacuate the refrigerant system. Adjust the refrigerant oil level. Charge the refrigerant system. Refer to PLUMBING, STANDARD PROCEDURE .
- Connect negative battery cable.
- Install the air intake assembly.
- Start engine and check fan operation.