Module, Active Damping Control (ADCM): Installation
WARNING: This page is about a different car, the 2018 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the Active Damping Control Module (ADCM) wire harness connectors.
- Slide the ADCM (2) into position making sure the latches secure the ADCM.
- From behind/under the left front seat, install the cover panel on the electronic module tub (4).
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
- Perform the ADCM Verification Test.