Module, Active Damping Control (ADCM): Removal
WARNING: This page is about a different car, the 2018 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- Position the left front seat to its full forward position.
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
- From behind/under the left front seat, remove the cover panel from the electronic module tub (4) to access the Active Damping Control Module (ADCM) (2).
- Release the integral latches that secure the ADCM (2) to the mounting bracket and slide the module upward to remove it from the mounting bracket.
- Disconnect the ADCM wire harness connectors.