Module, Electronic Limited Slip Differential (ELSD): Installation
WARNING: This page is about a different car, the 2018 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- Install the module in the vehicle.
- Secure the module mounting nuts (2) and tighten to 7 N.m (5 ft. lbs.).
- Connect the body wire harness connectors (3) to the module connector receptacle.
- Install carpet in original position.
- Install left rear seat. Refer to SEAT, FRONT, REMOVAL .
- Connect the negative battery cable., for battery location and cable connection procedure. Refer to CABLES, BATTERY, INSTALLATION .
- Perform the Electronic Limited Slip Differential (ELSD) verification test. Refer to STANDARD PROCEDURE .