Module, Keyless Ignition Node (Kin): Installation
WARNING: This page is about a different car, the 2018 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- Install the two screws (1) securing the KIN module to the bezel.
- Connect the wire harness connector (1) for the Keyless Ignition Node (KIN) module.
- Install the bezel to the dashboard cover then install two screws (1) that secure the bezel to the dashboard cover.
- Place the steering column gap hider back to its installed position, engaging all the snap clips.
- Install the instrument panel center bezel. Refer to BEZEL, INSTRUMENT PANEL, CENTER, INSTALLATION .
- If the KIN is being replaced, perform the RFHM verification test. Refer to STANDARD PROCEDURE .