Module, Power Liftgate Control (PLGM): Installation
WARNING: This page is about a different car, the 2018 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- Position the Power LiftGate Module (PLGM) (2) to the left lower inner D-pillar (1) in the vehicle.
- Engage the two tabs integral to the lower end of the PLGM housing into the slots in the lower left inner D-pillar.
- Press the top of the PLGM housing against the lower left inner D-pillar far enough for the latch feature integral to the upper end of the PLGM housing to engage the clearance hole in the inner D-pillar.
- Reconnect the two body wire harness (3) connectors to the PLGM connector receptacles.
- Reinstall the quarter trim panel to the lower left inner D-pillar. Refer to PANEL, QUARTER TRIM, INSTALLATION .
- Connect the battery negative cable.
- Using the diagnostic scan tool, navigate to the PLGM "Misc Functions" menu and perform the "Calibrate Liftgate" routine.