Module, Power Liftgate Control (PLGM): Removal
WARNING: This page is about a different car, the 2018 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect and isolate the battery negative cable.
- Move the quarter trim panel from the lower left inner D-pillar (1) far enough to access the Power LiftGate Module (PLGM) (2). Refer to PANEL, QUARTER TRIM, REMOVAL .
- Disconnect the two body wire harness (3) connectors from the PLGM connector receptacles.
- Depress the latch feature integral to the upper end of the PLGM housing and pull the top of the PLGM away from the lower left inner D-pillar.
- Disengage the two tabs integral to the lower end of the PLGM housing from the slots in the lower left inner D-pillar.
- Remove the PLGM from the vehicle.