Diagnostic Test
- DETERMINE ACTIVE OR STORED DTC NOTE:
Make sure the battery is fully charged.
- Turn the ignition on.
- Wait 12 seconds, then with the scan tool, read all active ORC DTCs.
Is the DTC active or stored?
ORC - ACTIVE DTC
- Go to 2
ORC - STORED DTC
- Perform the RESTRAINTS SYSTEM INTERMITTENT TEST. Refer to RESTRAINTS SYSTEM INTERMITTENT TEST
- CHECK ORC PRESENT CONFIGURATION
- With the scan tool, check for ORC present configuration.
Does the Vehicle Configuration in the BCM match the Vehicle Configuration in the ORC?
Yes
WARNING:If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to take the proper precautions can result in accidental airbag deployment and serious or fatal injury.
WARNING:To avoid serious or fatal injury, turn the ignition off, disconnect the battery and wait two minutes before proceeding.
WARNING:If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to follow these instructions may result in possible serious or fatal injury.
- Replace the Occupant Restraint Controller (ORC) in accordance with Service Information. Refer to MODULE, OCCUPANT RESTRAINT CONTROL (ORC), REMOVAL AND INSTALLATION .
- Perform the RESTRAINTS SYSTEM VERIFICATION TEST. Refer to RESTRAINTS SYSTEM VERIFICATION TEST .
No
- Perform the ORC PROXII to configure the module in accordance with the service information.
NOTE:The ORC Reset Function must be performed after the repair to force the module to retest for this DTC. Access the Miscellaneous Function or Diagnostic Procedures menu from the ORC ECU Overview screen on the scan tool to perform this operation.
- With the scan tool, check for ORC present configuration.