LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2020 >> Grand Cherokee Laredo, AWD, Automatic T/Case Control >> Repair and Diagnosis >> External Pages >> Different car >> Section 337 (Front Suspension & Wheel Alignment) >> Wheel Alignment >> Technical Specifications >> Set-To Specifications
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Set-To Specifications

WARNING: This page is about a different car, the 2019 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

Specifications are in degrees. 

NOTE:

With service there is both a set-to and service measurement check specifications. Set-to specifications are the parameters and tolerances used when adjusting alignment is necessary. A measurement specification is for the initial measurement of a vehicle in service. If this vehicle does not pass the measurement specification then the alignment should be adjusted to the set-to specification. Measurement specification is due to variation from measurement tools and setting.

Front Alignment Specifications
  Total Toe(1) Left Caster Right Caster Cross Caster Left Camber Right Camber Cross Camber
Aero Suspension  0.20° +/- 0.13° 7.32° +/- 0.50° 7.32° +/- 0.50° 0.00° +/- 0.50° -0.63° +/- 0.50° -1.03° +/- 0.50° 0.40° +/- 0.50°
Base Suspension (LHD)  0.20° +/- 0.13° 6.95° +/- 0.50° 6.95° +/- 0.50° 0.00° +/- 0.50° -0.38° +/- 0.50° -0.78° +/- 0.50° 0.40° +/- 0.50°
Base Suspension (RHD)  0.20° +/- 0.13° 7.15° +/- 0.50° 6.75° +/- 0.50° 0.40° +/- 0.50° -0.88° +/- 0.50° -0.28° +/- 0.50° -0.60° +/- 0.50°
Air Suspension (Aero Mode) (LHD)  0.20° +/- 0.13° 7.55° +/- 0.50° 7.55° +/- 0.50° 0.00° +/- 0.50° -0.75° +/- 0.50° -1.15° +/- 0.50° 0.40° +/- 0.50°
Air Suspension (Aero Mode) (RHD)  0.20° +/- 0.13° 7.75° +/- 0.50° 7.35° +/- 0.50° 0.40° +/- 0.50° -1.25° +/- 0.50° -0.65° +/- 0.50° -0.60° +/- 0.50°
SRT8 (LHD) (with 3season tires)  0.20° +/- 0.13° 6.67° +/- 0.55° 6.67° +/- 0.55° 0.00° +/- 0.55° -1.68° +/- 0.55° -1.98° +/- 0.55° 0.30° +/- 0.55°
SRT8 (RHD) (with 3 season tires)  0.20° +/- 0.13° 6.67° +/- 0.55° 6.67° +/- 0.55° 0.00° +/- 0.55° -1.98° +/- 0.55° -1.68° +/- 0.55° -0.30° +/- 0.55°
SRT8 (LHD) (with 4 season tires)  0.20° +/- 0.13° 6.67° +/- 0.55° 6.67° +/- 0.55° 0.00° +/- 0.55° -1.68° +/- 0.55° -1.98° +/- 0.55° 0.30° +/- 0.55°
SRT8 (RHD) (with 4 season tires)  0.20° +/- 0.13° 6.67° +/- 0.55° 6.67° +/- 0.55° 0.00° +/- 0.55° -1.98° +/- 0.55° -1.68° +/- 0.55° -0.30° +/- 0.55°
SRT8 (Trackhawk)  0.20° +/- 0.13° 7.00° +/- 0.55° 7.00° +/- 0.55° 0.00° +/- 0.55° -1.68° +/- 0.55° -1.98° +/- 0.55° 0.30° +/- 0.55°
Notes:
Positive toe (+) is toe-in and negative toe (-) is Toe-out.
(1) TOTAL TOE is the sum of both the left and right wheel toe settings. TOTAL TOE should be equally split between each wheel on the same axle to ensure the steering wheel is centered after setting toe.
Rear Alignment Specifications
LHD and RHD Toe Total Toe(1) Thrust Angle Camber Cross Camber
Aero Suspension  0.10° +/- 0.15° 0.20° +/- 0.30° 0.00° +/- 0.15° -0.88 +/- 0.55 0.00° +/- 0.50°
Base Suspension  0.10° +/- 0.15° 0.20° +/- 0.30° 0.00° +/- 0.15° -0.54 +/- 0.55° 0.00° +/- 0.50°
Air Suspension (Aero Mode)  0.20° +/- 0.15° 0.40° +/- 0.30° 0.00° +/- 0.15° -1.09° +/- 0.55° 0.00° +/- 0.50°
SRT8  0.25° +/- 0.10° 0.25° +/- 0.20° 0.00° +/- 0.10° -1.30° +/- 0.40° 0.00° +/- 0.55°
Notes:
Positive toe (+) is toe-in and negative toe (-) is Toe-out.
(1) TOTAL TOE is the sum of both the left and right wheel toe settings. TOTAL TOE should be equally split between each wheel on the same axle to ensure the steering wheel is centered after setting toe.