LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2020 >> Renegade Trailhawk >> Repair and Diagnosis >> Engine Performance >> 1.3L Ignition System >> Sensor, Camshaft Position >> Removal And Installation >> Removal
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Removal And Installation: Removal

  1. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  2. Disconnect and isolate the negative battery cable.
  3. Remove the catalytic converter. Refer to CONVERTER, CATALYTIC, REMOVAL AND INSTALLATION .
    GC0190216Courtesy of CHRYSLER GROUP, LLC
  4. Remove the bolt (1a) and the heat shield (1b).
    GC0188688Courtesy of CHRYSLER GROUP, LLC
  5. Disconnect the wiring harness connector (1) from the Camshaft Position (CMP) sensor.
    GC0189008Courtesy of CHRYSLER GROUP, LLC
  6. Remove the CMP sensor (1) complete with O-ring.
scientia non olet · About LEMON Manuals