Diagnostic Test

CHECK FOR AN ACTIVE DTC 

1. Turn the ignition on.
2. Actuate the Flash To Pass/Optical Horn Switch twice.
3. With the scan tool, read DTCs.

   Does the scan tool display this DTC as active?

   Yes 

   • If the Flash To Pass/Optical Horn Switch is free of any debris or foreign material that may cause a stuck switch, replace the Steering Column Control Module (SCCM) in accordance with the Service Information. Refer to MODULE, STEERING COLUMN CONTROL (SCCM), REMOVAL .
   • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .

   No 

   • Test complete. The condition or conditions that originally set this DTC are not present at this time.
   • Perform the appropriate TESTING FOR AN INTERMITTENT diagnostic procedure. Refer to TESTING FOR AN INTERMITTENT CONDITION .