Diagnostic Test

READ AND RECORD DTCS AND ENVIRONMENTAL DATA - ERASE DTCS AND CHECK FOR THE DTC TO RETURN
1. With the scan tool, read DTCs in all Electronic Control Units (ECUs) and record on the repair order.
2. For future reference, with the scan tool, run and save a vehicle Scan Report and all related recorded data.
3. With the scan tool, erase all DTCs.
4. Turn the ignition off for a minimum of 10.0 seconds.
5. Turn the ignition on.
6. Using the When Monitored and Set Conditions above and recorded data, operate the vehicle in the conditions that set the DTC.
7. With the scan tool, read RBSS DTCs.
  Did the DTC return?
  
  Yes
  - Go To 2
  No
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
REPROGRAM RIGHT BLIND SPOT MODULE.
1. Reprogram the RBSS in accordance with the Service Information.
2. With the scan tool, read DTCs.
  Does scan tool display active DTC?
  
  Yes
  - Replace the RBSS in accordance with the Service Information. Refer to SENSOR, BLIND SPOT, REMOVAL .
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Test complete. Reprogramming corrected the DTC