Diagnostic Test

CHECK FOR AN ACTIVE DTC
NOTE:
A vehicle operator leaning or pushing on the shift lever for more than 60 seconds could set this DTC.
1. With the scan tool, read the DTCs and record on the repair order.
2. Record the Event Data and Environmental Data.
3. With the scan tool, erase DTCs.
4. Using the recorded Event and Environmental Data, along with the When Monitored and Set Conditions above, operate the vehicle in the conditions that set the DTC.
5. Operate the Autostick in the upshift and downshift positions. Shift lever should return to normal position when released.
6. With the scan tool, read ESM DTCs.
  Did the Shift Lever stick in either of the Autostick positions or did the DTC reset?
  
  Yes
  - Go To 2
  No
  - Perform the TESTING FOR AN INTERMITTENT CONDITION procedure. Refer to TESTING FOR AN INTERMITTENT CONDITION .
CHECK RELATED HARNESS CONNECTIONS
1. Disconnect all ESM harness connectors.
2. Disconnect all related in-line harness connections (if equipped).
3. Disconnect the related component harness connectors.
4. Inspect harness connectors, component connectors, and all male and female terminals for the following conditions:
  - Proper connector installation.
  - Damaged connector locks.
  - Corrosion.
  - Other signs of water intrusion.
  - Weather seal damage (if equipped).
  - Bent terminals.
  - Overheating due to a poor connection (terminal may be discolored due to excessive current draw).
  - Terminals that have been pushed back into the connector cavity.
  - Perform a terminal drag test on each connector terminal to verify proper terminal tension.
  Repair any conditions that are found.
5. Reconnect all ESM harness connectors. Be certain that all harness connectors are fully seated and the connector locks are fully engaged.
6. Reconnect all in-line harness connectors (if equipped). Be certain that all connectors are fully seated and the connector locks are fully engaged.
7. Reconnect all related component harness connectors. Be certain that all connectors are fully seated and the connector locks are fully engaged.
8. With the scan tool, erase DTCs.
9. Using the recorded Event and Environmental Data, along with the When Monitored and Set Conditions above, operate the vehicle in the conditions that set the DTC.
10. With the scan tool, read ESM DTCs.
  Did the DTC return?
  
  Yes
  - Replace the Electronic Shift Module (ESM) in accordance with the Service Information. Refer to MODULE, ELECTRONIC SHIFT (ESM), REMOVAL .
  - Perform the ESM VERIFICATION TEST. Refer to ESM VERIFICATION TEST .
  No
  - Perform the ESM VERIFICATION TEST. Refer to ESM VERIFICATION TEST .
  - Test complete.