HVAC Verification Test

Perform the following procedures to verify that the repair(s) are valid.

1. Make sure that all accessories are turned OFF.
2. Make sure that the battery is fully charged.
3. Turn the ignition OFF.
4. Disconnect all jumper wires and reconnect all previously disconnected components and connectors.
5. With the scan tool, record and erase all DTCs from ALL modules.
6. Turn the ignition OFF, disconnect the scan tool from the Data Link Connector (DLC). Open the door and close the door. Wait a minimum of 30 seconds, then turn the ignition ON. Reconnect the scan tool.
   NOTE:

   Disconnecting the scan tool and opening and closing the door will allow the controller to enter into sleep mode.

7. With the scan tool, perform the HVAC ACTUATOR CALIBRATION TEST.
8. Start and run the engine for two minutes while operating all functions of the system that caused the original concern.
9. With the scan tool, check for DTCs in all modules.

Are there any DTCs set? 

Yes 

• Perform the appropriate diagnostic procedure(s). Refer to DIAGNOSTIC CODE INDEX .

No 

• Repair is complete.