Door Module Learn Procedures

NOTE:

This procedure must be performed anytime the power window system has been serviced in either front door or when there is a possible concern with a door module calibration.
The battery must be fully charged or the vehicle running before proceeding with the learn procedure.
All doors must be completely closed before proceeding.
It is suggested to sit inside the vehicle in the drivers seat and close the door.

Express-up / Express-down possible concerns.

Glass will not lower all the way down flush to the belt-line.
Glass will not raise fully; wind noise / water leak.
Glass will not raise automatically (Express-up) after lifting the switch to the second detent and releasing.

To relearn the door module memory after module replacement, perform the following procedure:

Check and repair any door module Diagnostic Trouble Codes (DTCs) unrelated to missing calibration before proceeding.
Using the window switch, lower the door glass to the full-down position by pushing down (depress) the window switch to its second detent and hold the switch until the door glass is fully open. Continue to hold the window switch down for two seconds after the door glass is fully open.
Raise the door glass to the full-up position by pulling up on the window switch and hold the switch until the door glass is fully closed. Continue to hold the window switch up for two seconds after the door glass is full closed.
Code should now be stored. Clear code and test window operations.

To relearn the door module memory after window/regulator replacement, perform the following procedure:

Using the scan tool, go to the network topology screen.
Click on the "Diagnostic Procedures" tab at the lower portion of the screen.
Run the "ECU Reset" for the DDM/PDM.
A DDM/PDM calibration missing DTC will now set.
Using the window switch, lower the door glass to the full-down position by pushing down (depress) the window switch to its second detent and hold the switch until the door glass is fully open. Continue to hold the window switch down for two seconds after the door glass is fully open.
Raise the door glass to the full-up position by pulling up on the window switch and hold the switch until the door glass is fully closed. Continue to hold the window switch up for two seconds after the door glass is full closed.
The DTC will now be stored. Clear the DTC and test window operations.