LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2021 >> Gladiator Mojave, Full Time T/Case Control, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Electronic Control Modules (Service Information)) >> Module, Instrument Panel Cluster (IPC) >> Removal And Installation >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal And Installation: Removal

WARNING: This page is about a different car, the 2022 Chrysler Voyager and 2022 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the instrument cluster bezel. Refer to BEZEL, INSTRUMENT CLUSTER, REMOVAL AND INSTALLATION .
  3. Using a trim stick or equivalent, release the top portion of the gap hider from the instrument panel to gain access to the lower instrument panel cluster fasteners.
    GC0177406Courtesy of CHRYSLER GROUP, LLC
  4. Remove the four screws (1) that secure the Instrument Panel Cluster (IPC) to the instrument panel.
  5. Pull the top of the IPC rearward far enough to access and disconnect the instrument panel wire harness connectors from the connector receptacles on the back of the IPC.
  6. Remove the IPC from the instrument panel.
scientia non olet · About LEMON Manuals