LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2021 >> Gladiator Mojave, Full Time T/Case Control, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Electronic Control Modules (Service Information)) >> Module, Park Assist (PAM) >> Removal And Installation >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal And Installation: Removal

WARNING: This page is about a different car, the 2022 Chrysler Voyager and 2022 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the trim from the right quarter inner panel to access the Park Assist Module (PAM), which is located to the rear of the C-pillar and above the right rear wheel housing. Refer to PANEL, QUARTER TRIM, REMOVAL AND INSTALLATION .
    GC0177893Courtesy of CHRYSLER GROUP, LLC
  3. Disconnect the body wire harness connectors (3) from the PAM (1) connector receptacles.
  4. Remove the fasteners (2) that secure the PAM to the right quarter inner panel.
  5. Remove the PAM from the vehicle.
scientia non olet · About LEMON Manuals