LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2021 >> Gladiator Mojave, Full Time T/Case Control, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Electronic Control Modules (Service Information)) >> Module, Radio Frequency (RF Hub) >> Removal And Installation >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal And Installation: Removal

WARNING: This page is about a different car, the 2022 Chrysler Voyager and 2022 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Partially remove the headliner to access the Radio Frequency Hub Module (RFHM) located at the center rear. Refer to HEADLINER, REMOVAL AND INSTALLATION .
  3. Disconnect all of the electrical connectors at the RFHM.
    GC0177331Courtesy of CHRYSLER GROUP, LLC
  4. Remove the fasteners (1) and remove the RFHM from the vehicle.
scientia non olet · About LEMON Manuals