Diagnostic Test

READ AND RECORD DTCS AND ENVIRONMENTAL DATA - ERASE DTCS AND CHECK FOR THE DTC TO RETURN 

1. With the scan tool, read DTCs in all Electronic Control Units (ECUs) and record on the repair order.
2. With the scan tool, run a vehicle Scan Report, or record the Environmental Data related to the DTCs.
3. With the scan tool, erase all DTCs.
4. Turn the ignition off for a minimum of 10.0 seconds.
5. Turn the ignition on.
6. Using the recorded Environmental Data and the When Monitored Conditions above, operate the vehicle in the conditions that set the DTC.
7. With the scan tool, read Body Control Module (BCM) DTCs.

Did the DTC return?

Yes 

• Replace the Inside Rear View Mirror in accordance with the Service Information. Refer to MIRROR, REARVIEW, REMOVAL AND INSTALLATION .
• Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .

No 

• Perform the appropriate INTERMITTENT CONDITION diagnostic procedure. Refer to STANDARD PROCEDURE .