LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2021 >> Gladiator Mojave, Part Time T/Case Control, Standard Trans >> Repair and Diagnosis (Single Page) >> Electrical >> Body Electrical >> Power Accessories >> Universal Transmitter >> Standard Procedure >> Programming HOMELINK® Transceiver Codes >> CANADIAN Programming/Gate Programming
April 5, 2026: LEMON Manuals is launched! Read the announcement.

CANADIAN Programming/Gate Programming

Canadian radio-frequency laws require transmitter signals to "time-out" (or quit) after several seconds of transmission which may not be long enough for the HomeLink® transceiver to pick up the signal during programming. Similar to this Canadian law, some U.S. gate openers are designed to "time-out" in the same manner.

If located in Canada or are having difficulties programming a gate opener by using the "Programming" procedures (regardless of location), replace "Programming HomeLink® Transceiver Codes" step 3  with the following:

NOTE:

When programming a garage door opener or gate opener, it is advised to unplug the device or move the vehicle out of range during the "cycling" process to prevent possible overheating.

  1. 3. Continue to press and hold the HomeLink® transceiver button while pressing and releasing every two seconds  ("cycle") the hand-held transmitter until the frequency signal has successfully been accepted. The indicator light will flash slowly and then rapidly. Proceed with "Programming" step 4 to complete.
scientia non olet · About LEMON Manuals