LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2021 >> Grand Cherokee SRT >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Electronic Control Modules (Service Information) >> Module, Adaptive Front Lighting System (AFLS) >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Module, Adaptive Front Lighting System (AFLS): Installation

WARNING:

To avoid serious or fatal injury when working on the High Intensity Discharge (HID) headlamp system, be certain to take the proper precautions. The headlamp switch must be in the OFF position. Disconnect and isolate the battery negative cable. There is a risk of fatal injury caused by contact with high voltage used in the HID headlamps. There is a risk of explosion or fire caused by highly flammable materials in the vicinity of damaged HID lighting elements. There is a risk of injury caused by exposure to Ultra Violet (UV) light, a risk of burns caused by high component operating temperatures, a risk of mercury poisoning through glass splinters produced by bursting HID lighting elements. There is also a risk of poisoning caused by inhalation of mercury vapors and by toxic salts and mercury compounds being ingested or coming into contact with the skin. Do not come into contact with parts that are under high voltage. Persons with active electronic implants (e.g. heart pacemakers) must never work on HID headlamps. Wear insulated safety shoes, safety glasses and protective gloves. Remove flammable materials and ensure sufficient ventilation in the working area.

GC0146879Courtesy of CHRYSLER GROUP, LLC
  1. Position the Adaptive Front Lighting System (AFLS) module (3) close enough to the receptacle, on the bottom of the right front lamp unit housing (1), and connect the wire harness connector to the front lamp unit connector receptacle on the upward-facing side of the AFLS module.
  2. Position the AFLS module onto the bottom of the right front lamp unit housing.
  3. Position the AFLS module cover plate onto the AFLS module, at the bottom of the right front lamp unit housing.
  4. Install and securely tighten the AFLS module cover plate screws (2) onto the right front lamp unit housing.
  5. Install the right front lamp unit. Refer to UNIT, FRONT LAMP, INSTALLATION .
  6. Connect the battery negative cable.
NOTE:

On vehicles equipped with the optional High Intensity Discharge (HID) headlamps, when the AFLS module is replaced, a scan tool MUST be used to initialize and calibrate the new AFLS module before the AFLS can operate properly. Refer to STANDARD PROCEDURE - AFLS CALIBRATION .

scientia non olet · About LEMON Manuals