Charging System (Service Information): Generator: Installation: 6.4L
- Position the generator to the engine.
- Install the mounting bolts (1). The lower mounting bolt goes in the rear mounting hole.
- Install the lower stud bolt (2) in the lower front mounting hole. Torque the bolts to the proper specifications. Refer to TORQUE SPECIFICATIONS .
- Install the ground wire on the lower mounting stud (2) and install the generator mounting nut finger tight and then tighten to the proper specifications. Refer to TORQUE SPECIFICATIONS .
- Snap the field wire connector (3) into the rear of the generator.
- Reposition the super charger coolant hoses and tighten the fastener securely.
- Install the B+ terminal eyelet to the generator output stud.
Tighten the mounting nut to the proper specifications. Refer to TORQUE SPECIFICATIONS .
CAUTION:Never force a belt over a pulley rim using a screwdriver. The synthetic fiber of the belt can be damaged.
CAUTION:When installing a serpentine accessory drive belt, the belt must be routed correctly. The water pump may be rotating in the wrong direction if the belt is installed incorrectly, causing the engine to overheat. Refer to belt routing label in engine compartment, or Refer to 5.7L/6.4L for the Belt Schematics .
- install the splash shield Refer to SHIELD, SPLASH, WHEELHOUSE, INSTALLATION .
- Install the supercharger belt tensioner Refer to the appropriate service information .
- Install the serpentine belt. Refer to REMOVAL .
- Install the air cleaner body. Refer to BODY, AIR CLEANER, INSTALLATION .
- Install the negative battery cable and tighten the nut to the proper specifications. Refer to TORQUE SPECIFICATIONS .