Removal And Installation: 1.3L

REMOVAL

NOTE:

If this Powertrain Control Module (PCM) is being replaced with a new unit, a diagnostic scan tool MUST be used to align the PROXI configuration data into the new PCM. Follow the routine outlined in the diagnostic scan tool for PROXI Configuration Alignment under Body Control Module (BCM) Miscellaneous Functions menu.

Disconnect and isolate negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
Remove the engine cover. Refer to COVER, ENGINE, REMOVAL AND INSTALLATION or COVER, ENGINE, REMOVAL AND INSTALLATION .

Courtesy of CHRYSLER GROUP, LLC
Release the upper fasteners (1a) and move the engine coolant supply reservoir (1b).
Press the lower fastener (2a) and move the reservoir (1b) outside of the working area.

Courtesy of CHRYSLER GROUP, LLC
Disconnect the Powertrain Control Module (PCM) wire harness connector (1).
Remove the fastener (2a) and disconnect the ground lead (2b) from the PCM.
Open the retainers (3) and move the battery wiring outside the working area.

Courtesy of CHRYSLER GROUP, LLC
Remove the fasteners (1a) and the PCM and shield (1b).

INSTALLATION

Courtesy of CHRYSLER GROUP, LLC

Install the PCM with shield (1b) and securely tighten the fasteners (1a).

Courtesy of CHRYSLER GROUP, LLC
Position the battery wiring in the working area and close the retaining clips (3).
Connect the ground wire (2b) and fastener (2a) to the PCM.
Connect the PCM wire harness connectors.

Courtesy of CHRYSLER GROUP, LLC
Install the pressurized coolant bottle (1b) and engage the lower fastener.
Engage the upper fasteners (1a) to the pressurized coolant bottle (1b).
Install the engine cover. Refer to COVER, ENGINE, REMOVAL AND INSTALLATION or COVER, ENGINE, REMOVAL AND INSTALLATION .
Connect the negative battery cable. If equipped with an IBS, connect the IBS connector.
If this Powertrain Control Module (PCM) is being replaced with a new unit, a diagnostic scan tool MUST be used to align the PROXI configuration data into the new PCM. Follow the routine outlined in the diagnostic scan tool for PROXI Configuration Alignment under Body Control Module (BCM) Miscellaneous Functions menu.
Select the "Miscellaneous Functions" menu in PCM.
Select and perform the "replacement unit" routine.
With key in the OFF position and with the hazard lights turned ON, go to " BCM", select the "miscellaneous functions" menu and then perform the "transfer secret key" routine.