October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.
Removal And Installation: Removal
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
- Remove the engine cover. Refer to
COVER, ENGINE, REMOVAL AND INSTALLATION
.
- Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE
.
 Courtesy of CHRYSLER GROUP, LLC
|
- Disconnect the wire harness connector (1) from the oxygen sensor upstream of the catalyst.
 Courtesy of CHRYSLER GROUP, LLC
|
- Disengage the oxygen sensor wire harness (1), remove the fastener and the bracket.
- Remove the fasteners and the exhaust manifold upper heat shield (2).
 Courtesy of CHRYSLER GROUP, LLC
|
- Remove the fasteners and the heat shield (1) below the exhaust manifold.
 Courtesy of CHRYSLER GROUP, LLC
|
- Disconnect the knock sensor wire harness connector (1).
- Remove and DISCARD
the knock sensor fastener (2), then remove the knock sensor.