Removal And Installation: Gaiter: Notes

REMOVAL 

1. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
2. Remove the tire and wheel assembly. Refer to TIRE AND WHEEL, REMOVAL AND INSTALLATION .
3. Remove the outer tie rod end. Refer to TIE ROD, STEERING, REMOVAL AND INSTALLATION .

   Courtesy of CHRYSLER GROUP, LLC

   1 - Clamp	4 - Tie Rod Jam Nut
   2 - Inner Tie Rod Boot	5 - Outer Tie Rod
   3 - Clamp

4. Remove the tie rod jam nut.
   NOTE:

   Count the number of turns. This will give a good starting point when reassembling and when setting toe.

5. Remove the clamps from the inner tie rod boot.
6. Remove and the inner tie rod boot.

INSTALLATION 

During installation, torque the fasteners to the specifications in the torque table(s) below.

Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.

• Perform the wheel alignment standard procedure. Refer to WHEEL ALIGNMENT, STANDARD PROCEDURE .

TORQUE SPECIFICATIONS