Diagnostic Test
CHECK IF THE DTC IS ACTIVE
- Ignition on, engine not running.
- With the scan tool, record and erase Memory Seat Module-Driver (MSMD) DTCs.
- Cycle the ignition switch from off to on.
- With the scan tool, read MSMD DTCs.
Does the scan tool display this DTC as active?
Yes
- Attempt to update (flash) the MSMD. If you are unable to update the controller, or if this DTC continues to reset after updating, replace and program the Memory Seat Module-Driver (MSMD) in accordance with the Service Information. Refer to MODULE, MEMORY SEAT (MSM), REMOVAL and MODULE, MEMORY SEAT (MSM), INSTALLATION .
- Perform POWER SEAT SYSTEM VERIFICATION TEST. Refer to POWER SEAT SYSTEM VERIFICATION TEST .
No
- Perform the TESTING FOR AN INTERMITTENT CONDITION procedure. Refer to TESTING FOR AN INTERMITTENT CONDITION .