LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2024 >> Compass Latitude >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Electronic Control Modules (Service Information) (2 Of 2) >> Module, Global Telematics Box >> Removal And Installation >> Global Telematics Box Module
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Global Telematics Box Module

REMOVAL 

NOTE:

If this Electronic Control Unit (ECU) is being replaced with a new unit, a diagnostic scan tool MUST be used to align the PROXI configuration data into the new ECU. Follow the routine outlined in the diagnostic scan tool for PROXI Configuration Alignment under Body Control Module (BCM) Miscellaneous Functions menu.

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the floor console. Refer to CONSOLE, FLOOR, REMOVAL AND INSTALLATION .
  3. Remove the fasteners (1) from the Global Telematics Box Module TBM2 (2).
    GC0202691Courtesy of CHRYSLER GROUP, LLC
  4. Disconnect the wire harness connectors (3) from the bottom of the (TBM2) (2).
  5. Remove the TBM2 (2) from the vehicle.

INSTALLATION 

  1. Position the TBM2 (2) to the instrument panel.
  2. Connect the wire harness connectors (3) to the bottom of the TBM2 (2).
    GC0202691Courtesy of CHRYSLER GROUP, LLC
  3. Install the fasteners (1) and tighten securely.
  4. Install the floor console. Refer to CONSOLE, FLOOR, REMOVAL AND INSTALLATION .
  5. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
scientia non olet · About LEMON Manuals