LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2024 >> Gladiator Nighthawk, Part Time T/Case Control, Automatic Trans >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Drivers Assistance System Module - DTCS B1EAD-2A To C2318-4B >> DTC Troubleshooting >> C00C1-87 Front Radar Module "B" - Missing Message >> Diagnostic Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic Test

  1. CHECK FOR ANY SERVICE BULLETINS OR MODULE SOFTWARE UPDATES 
    1. Check for any applicable Service Bulletins or Flash updates related to the DTC.

      Are there any applicable Service Bulletins or Flash updates?

      Yes 

      No 

      • Go To  2
  2. READ AND RECORD DTCS AND ENVIRONMENTAL DATA - ERASE DTCS AND CHECK FOR THE DTC TO RETURN 
    1. With the scan tool, read DTCs in all Electronic Control Units (ECU's) and record on the repair order.
    2. For future reference, with the scan tool, run and save a vehicle Scan Report and all related recorded data.
    3. With the scan tool, erase all DTCs.
    4. Turn the ignition off for a minimum of 10.0 seconds.
    5. Turn the ignition on.
    6. Using the When Monitored and Set Conditions above and recorded data, operate the vehicle in the conditions that set the DTC.
    7. With the scan tool, read DTCs.

      Did the DTC return?

      Yes 

      • Go To  3

      No 

  3. CHECK THE DASM AND RADAR HARNESS CONNECTORS AND TERMINALS 
    1. Turn the ignition off.
    2. Check the DASM and Radar harness connectors for proper connection at both the DASM and the Radar.
    3. Verify that the connector is completely plugged in and locked prior to disconnecting.
    4. Disconnect the DASM and the Radar harness connectors and check for pushed out or spread terminals, brinelling on terminals, discoloration from excessive heat, or corrosion and water intrusion.

      Were any issues found with the connectors or terminals?

      Yes 

      No