Diagnostic Test

CHECK FOR AN ACTIVE DTC
1. Turn the ignition on.
2. With the scan tool, read DTCs and record on vehicle work order.
  Is the DTC active?
  
  Yes
  - Go To 2
  No
  - Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
  - Perform the RESTRAINTS SYSTEM VERIFICATION TEST. Refer to: RESTRAINTS SYSTEM VERIFICATION TEST .
CAN BUS DTCS SET IN BODY CONTROL MODULE (BCM)
NOTE:
Verify that the BCM has the correct vehicle configuration before proceeding with this test step.
1. With the scan tool, read DTCs in the BCM.
  Are there any active CAN Bus DTCs present?
  
  Yes
  - Perform the Stored Lost Communication DTCs diagnostic procedure. Refer to: STORED LOST COMMUNICATION DTCS .
  No
  - Replace the ORC in accordance with the Service Information. Refer to: OCCUPANT RESTRAINT CONTROLLER (ORC), REMOVAL AND INSTALLATION .
  - Perform the RESTRAINTS SYSTEM VERIFICATION TEST. Refer to: RESTRAINTS SYSTEM VERIFICATION TEST .