LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2024 >> Gladiator Nighthawk, Part Time T/Case Control, Automatic Trans >> Repair and Diagnosis (Single Page) >> Transmission >> Automatic Trans >> 8HP50/850RE Automatic Transmission - Pre-Diagnostic Troubleshooting Procedure, Transmission Verification Test And TCM Adaptation >> Standard Procedure >> Module Programming
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Module Programming

PROGRAMMING THE TRANSMISSION CONTROL MODULE (TCM) 

NOTE:

New TCMs are supplied with generic software. When replacing a TCM, it must be programmed with vehicle specific software.

NOTE:

Failure to properly program the TCM will cause Diagnostic Trouble Codes (DTCs) to be set.

  1. The following conditions must be met during the reprogramming procedure:
    • Battery must be maintained between 10 and 16 volts. Connect a battery charger if necessary.
    • Ambient temperature must be between 0°C (32°F) 60°C (140°F).
    • Gear Selector must be in PARK.
  2. With the scan tool, download the appropriate TCM flash file to the scan tool.
  3. Turn the ignition on.
  4. Following the menu on the scan tool, program the TCM.
  5. Perform the TCM ADAPTATION procedure. Refer to: TRANSMISSION CONTROL MODULE (TCM) ADAPTATION .
  6. Perform the TRANSMISSION VERIFICATION TEST. Refer to: TRANSMISSION VERIFICATION TEST .

Is the Programming Procedure and TCM Adaptation Procedure complete?

Yes

scientia non olet · About LEMON Manuals