Monitor Scantool Data
- Connect scantool to Data Link Connector (DLC).
- Monitor the "INTAKE MAP" parameter on scantool.
- Specification:
- IG key "ON", Engine "OFF": Approx. 1010 mbar ~ 1040 mbar
- IG key "ON", Engine "ON": Approx. 310 mbar ~ 370 mbar
- Specification:
- Is the sensor's signal near the specified value?
YES
- Fault is intermittent caused by poor contact in the sensor's and/or ECM's connector.
- Fault was repaired and ECM memory was not cleared.
- If the problem works out, Go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Go to "Inspection & Repair" procedure.