Ground Circuit inspection

Check for Open in Harness 

1. IG KEY: OFF, Engine: OFF
2. Disconnect FLS connector (C-06).
3. Measure resistance between terminal 3 of the FLS harness connector and chassis ground.
   1. Specification: Approx. 0Ω
      Fig 1: Measuring Resistance Between Terminal 3 Of FLS Harness Connector And Chassis Ground

      
4. Is the resistance near the specified value?

   YES

   1. Go to "SIGNAL CIRCUIT INSPECTION " procedure.

   NO

   1. Repair open in harness, Go to "VERIFICATION OF VEHICLE REPAIR " procedure.