LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Kia >> 2007 >> Rio Base, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> DTC Troubleshooting Procedures (2 Of 2) >> DTC P0533 A/C Refrigerant Pressure Sensor "A" Circuit High Input >> Component Inspection
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Component Inspection

  1. A/C pressure sensor inspection
    1. Key "OFF" and connect the scantool.
    2. Connect the probe to A/C pressure sensor signal and select the oscilloscope in the menu.
    3. Check the change of waveform with A/C "ON" and A/C "OFF" after engine start.
      VOLTAGE SPECIFICATION

      Pressure(psi)  14.7 100 200 300 470
      Voltage(V)  0.5 1.25 2.13 3.00 4.50
      Fig 1: Identifying A/C Pressure Sensor Connector Terminals
      G04862311Courtesy of KIA MOTORS AMERICA, INC.
    4. Is the measured waveform of A/C pressure sensor normal?

      YES 

      • Substitute with a known - good ECM/PCM and check for proper operation. If the problem is corrected, replace ECM/PCM and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

      NO 

      • Substitute with a known - good A/C pressure sensor and check for proper operation. If the problem is corrected, replace A/C pressure sensor and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
      NOTE: There is a memory reset function on scantool that can erase optional parts automatically detected and memorized by ECM/PCM.
      Before or after testing ECM/PCM on the vehicle, use this function to reuse the ECM/PCM
scientia non olet · About LEMON Manuals