Air Bag Module And Clock Spring: Installation
- Disconnect the negative (-) cable from battery and wait for at least three minutes.
- Remove the ignition key from the vehicle.
- Connect the clock spring harness connetor and horn harness connector to the clock spring.
- Set the clock spring on neutral position and after turning the front wheels to the straight-ahead position, install the clock spring.
- Install the steering wheel column cover and the steering wheel. (Refer to STEERING COLUMN AND SHAFT )
- Connect the Driver Airbag (DAB) module connector and horn connector, then install the Driver Airbag (DAB) module on the steering wheel.
- Secure the Driver Airbag (DAB) with the new mounting bolts.
Tightening Torque (DAB Mounting Bolt)
: 0.8~1.1 kgf.m (7.9~10.8 Nm, 5.8~8.0 lb.ft)
- Connect the battery negative cable.
- After installing the airbag, confirm proper system operation:
- Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
- Make sure horn button works.