Main Harness Circuit Inspection

WARNING: This page is about a different variant/trim than selected.

Ignition "OFF".
Disconnect the battery (-) terminal cable from the battery and wait at least one minutes.
Disconnect FSIS connector and SRSCM main harness connector.
Measure resistance between terminal "1" or "2" of the FSIS harness connector and chassis ground.
Specification: ∞

Fig 1: Measuring Resistance Between Terminal 1 Or 2 Of FSIS Harness Connector And Chassis Ground
Is the measured resistance within specifications?
YES
- Go to "COMPONENT INSPECTION " procedure.
NO
- Substitute the SRS main harness and check for proper operation.
  If the problem is corrected, replace SRS main harness and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.