LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Kia >> 2008 >> Rio Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Automatic Transaxle System) >> Troubleshooting >> DTC P0707 Transaxle Range Switch-No Input >> Signal Circuit Inspection
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Signal Circuit Inspection

WARNING: This page is about a different variant/trim than selected.
  1. Ignition "OFF".
  2. Disconnect "TRANSAXLE RANGE SWITCH" and "PCM" connector.
  3. Measure resistance between each terminal of the sensor harness connector and PCM harness connector.

    Specification: See TRANSAXLE RANGE SWITCH SPECIFICATIONS CHART .

    TRANSAXLE RANGE SWITCH SPECIFICATIONS CHART

    RANGE L 2 P R D N
    Pin No of "TRANSAXLE RANGE SWITCH C11 No.2 C11 No.4 C11 No.9 C11 No.10 C11 No.11 C11 No.12
    Pin No of "PCM" harness C01-1 No.68 C01-1 No.89 C01-1 No.67 C01-1 No.88 C01-1 No.66 C01-1 No.91
    Specification 0Ω 0Ω 0Ω 0Ω 0Ω 0Ω
    Fig 1: Measuring Resistance Between Terminal Of Sensor Harness Connector
    G04862539Courtesy of KIA MOTORS AMERICA, INC.
  4. Is resistance within specifications?

    YES  : --> Go to "COMPONENT INSPECTION " procedure.

    NO  : --> Check for open in harness. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

scientia non olet · About LEMON Manuals