LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Kia >> 2008 >> Rio SX, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle System >> Troubleshooting >> DTC P0707 Transaxle Range Switch-No Input >> Signal Circuit Inspection
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Signal Circuit Inspection

  1. Ignition "OFF".
  2. Disconnect "TRANSAXLE RANGE SWITCH" and "PCM" connector.
  3. Measure resistance between each terminal of the sensor harness connector and PCM harness connector.

    Specification: See TRANSAXLE RANGE SWITCH SPECIFICATIONS CHART .

    TRANSAXLE RANGE SWITCH SPECIFICATIONS CHART

    RANGE L 2 P R D N
    Pin No of "TRANSAXLE RANGE SWITCH C11 No.2 C11 No.4 C11 No.9 C11 No.10 C11 No.11 C11 No.12
    Pin No of "PCM" harness C01-1 No.68 C01-1 No.89 C01-1 No.67 C01-1 No.88 C01-1 No.66 C01-1 No.91
    Specification 0Ω 0Ω 0Ω 0Ω 0Ω 0Ω
    Fig 1: Measuring Resistance Between Terminal Of Sensor Harness Connector
    G04862539Courtesy of KIA MOTORS AMERICA, INC.
  4. Is resistance within specifications?

    YES  : --> Go to "COMPONENT INSPECTION " procedure.

    NO  : --> Check for open in harness. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

scientia non olet · About LEMON Manuals