Ground Circuit Inspection

Check open in harness
1. IG "OFF".
2. Disconnect APS connector and then turn the ignition ON.
3. Measure voltage between terminal 6 of APS harness connector and chassis ground. (measurement "A")
4. Measure voltage between terminal 6 and 5 of APS harness connector. ( measurement "B")
  Specification : "A" - "B" = approx. below. 200mV.
  
  Fig 1: Measuring Voltage Between Terminal 6 And 5 Of APS Harness Connector. ( Measurement "B")
  Courtesy of KIA MOTORS AMERICA, INC.
5. Is the measured voltage within specification ?
  YES
  - Go to "COMPONENT INSPECTION " procedure.
  NO
  - Repair or replace contact resistance or open in harness and then, go to "VERIFICATION OF VEHICLE REPAIR " procedure.