Power Circuit Inspection

IG "OFF".
Disconnect APS connector.
IG "ON" & ENG "OFF".
Measure voltage between terminal 3 of APS harness connector and chassis ground.
Specification : Approx. 5V

Fig 1: Measuring Voltage Between Terminal 3 Of APS Harness Connector And Chassis Ground
Courtesy of KIA MOTORS AMERICA, INC.
Is the measured voltage within specification ?
YES
- Go to "SIGNAL CIRCUIT INSPECTION " procedure.
NO
- Repair or replace as necessary and then, go to "VERIFICATION OF VEHICLE REPAIR " procedure.