LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Kia >> 2009 >> Rondo EX, 2.4 8 >> Repair and Diagnosis >> Transmission >> Transmission Control Systems >> Automatic Transaxle Control System - F4A42 >> Input Speed Sensor >> Repair Procedures >> Replacement
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Repair Procedures: Replacement

  1. Remove the battery and air cleaner.
  2. Remove the transaxle range switch connector. (See AUTOMATIC TRANSAXLE SYSTEM - F4A42 ).
  3. Remove the control cable to transaxle range switch mounting nut.
  4. Remove the input shaft speed sensor (A).
    1. Disconnect the input shaft speed sensor connector.
    2. Remove the bolt (B).
      Fig 1: Identifying Input Shaft Speed Sensor & Bolt
      G06386462Courtesy of KIA MOTORS AMERICA, INC.
    3. Inspect the input shaft speed sensor bore.
  5. Apply a light coat of automatic transaxle fluid to the O-ring seal before installation.
  6. Install the input shaft speed sensor.
  7. Install the control cable mounting bracket.
  8. Connect the input shaft speed sensor connector.
  9. Install the holder of the control cable.
  10. Adjust the control cable to transaxle range switch and tighten the transaxle manual lever to the control cable mounting nut. (See AUTOMATIC TRANSAXLE SYSTEM - F4A42 ).
  11. Installation is the reverse of removal.
scientia non olet · About LEMON Manuals