LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Kia >> 2009 >> Sorento Base, A5SR2 >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> SRS Control Module (Air Bag) >> Front Impact Sensor (FIS) >> Repair Procedures >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Repair Procedures: Installation

CAUTION:
  • Do not turn the ignition switch ON and do not contact the battery cable while replacing the front impact sensor.
  1. Install the new Front Impact Sensor.
  2. Tighten the Front Impact Sensor mounting bolt.

    Tightening torque: 1.0 ~ 1.4 kgf.m (10.2 ~ 13.8 Nm, 7.5 ~ 10.2 lb.ft)

  3. Connect the Front Impact Sensor connector.
  4. Install the Front bumper seal board.
  5. Reconnect the battery negative cable.
  6. After installing the Front Impact Sensor, confirm proper system operation: Turn the ignition switch ON the SRS indicator light should be turned on for about six seconds and then go off.
scientia non olet · About LEMON Manuals