LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Kia >> 2009 >> Sorento Base, A5SR2 >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> SRS Control Module (Air Bag) >> Side Impact Sensor (SIS) >> Repair Procedures >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Repair Procedures: Installation

CAUTION:
  • Do not turn the ignition switch ON and do not connect the battery cable while replacing the side impact sensor.
  1. Install the new Side Impact Sensor with the bolt then connect the SRS harness connector to the Side Impact Sensor.

    Tightening torque: 1.0 ~ 1.4 kgf.m (10.2 ~ 13.8 Nm, 7.5 ~ 10.2 lb.ft)

  2. Install the center pillar trim. (Refer to INTERIOR )
  3. Install the door scuff trim. (Refer to INTERIOR )
  4. Install the lower anchor bolt.
  5. Reconnect the battery negative cable.
  6. After installing the Side Impact Sensor, confirm proper system operation: Turn the ignition switch ON, the SRS indicator light should be turned on for about six seconds and then go off.
scientia non olet · About LEMON Manuals