Inspection Procedure

Refer to PREPARATION OF INSPECTION .

1. Connect the battery negative cable to the battery.
2. Turn the ignition switch to ON.
3. Measure voltage between the terminal 3 of OC Sensor harness connector and chassis ground.

   specification (voltage) : Battery voltage

   Fig 1: Measuring Voltage Between Terminal 3 Of OC Sensor Harness Connector & Chassis Ground

   Courtesy of KIA MOTORS AMERICA, INC.
4. Is the measured voltage within specification?

   YES 

   • Check short to battery line.

   NO 

   • Repair or replace the wiring harness between the OC Sensor and ignition switch.

1. Measure voltage between the terminal 2 of OC Sensor harness connector and chassis ground.

   specification (voltage) : Approximately 0 V

   Fig 2: Measuring Voltage Between Terminal 2 Of OC Sensor Harness Connector & Chassis Ground

   Courtesy of KIA MOTORS AMERICA, INC.
2. Is the measured voltage within specification?

   YES 

   • Check short to ground.

   NO 

   • Repair the short to battery line circuit on wiring harness between the OC Sensor and the SRSCM.

1. Turn the ignition switch to LOCK.
2. Disconnect the battery negative cable from the battery.
3. Measure resistance between the terminal 2 of OC Sensor harness connector and chassis ground.
4. Measure resistance between the terminal 2 and 1 of OC Sensor harness connector

   Specification (resistance) : Infinite

   Fig 3: Measuring Resistance Between OC Sensor Harness Connector Terminals / Chassis Ground

   Courtesy of KIA MOTORS AMERICA, INC.
5. Is the measured resistance within specification?

   YES 

   • Check OC Sensor Circuit.

   NO 

   • Repair or replace the wiring harness between the OC Sensor and the SRSCM.

1. Measure resistance between the terminal 2 of OC Sensor harness connector and the terminal 70 of the SRSCM harness connector.

   specification (resistance) : below 1 Ω

   Fig 4: Measuring Resistance Between Terminal 2 Of OC Sensor Harness Connector & Terminal 70 Of SRSCM Harness Connector

   Courtesy of KIA MOTORS AMERICA, INC.
2. Is the measured resistance within specification?

   YES 

   • Check OC Sensor.

   NO 

   • Repair or replace the wiring harness between the OC Sensor and the SRSCM.

1. Replace the OC Sensor with a new one.
   • Refer to " Occupant Classification Sensor (OCS)  " .
2. Install the DAB module and connect the DAB connector.
3. Connect the connectors of the PAB, KAB, CAB, BPT, FIS and SIS.
4. Connect the SRSCM connector.
5. Connect the battery negative cable to the battery.
6. Connect the a Hi-Scan (Pro) to the data link connector.
7. Turn the ignition switch to ON and check the vehicle again.
8. Does Hi-Scan (Pro) indicate any DTC related to OC Sensor?

   YES 

   • Go to next step.

   NO 

   • Replace the OC Sensor.

Refer to CLEAR THE DTC AND CHECK THE VEHICLE AGAIN .