Short To Heater Circuit Inspection
- Ignition "OFF"
- Disconnect HO2S and PCM connectors.
- Measure resistance between terminals 6 and 1 of the sensor harness connector
- Measure resistance between terminals 6 and 2 of the sensor harness connector
- Measure resistance between terminals 6 and 3 of the sensor harness connector
- Measure resistance between terminals 6 and 4 of the sensor harness connector
Specification: Above 400kΩ
- Is resistance within the specification?
YES
- Go to "TERMINAL AND CONNECTOR INSPECTION " procedure
NO
- Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure