Repair procedures: Installation

Install the new O-ring to the output shaft speed sensor.
Remove the output speed sensor (A).
Tightening torque:

10~12Nm (1.0~1.2kgf.m, 7~8lb-ft)

CAUTION: While installing the output speed sensor, do not allow dust or other foreign particles to enter the transaxle.

Fig 1: Identifying Output Speed Sensor
Courtesy of KIA MOTORS AMERICA, INC.
Check the connector for dust, dirt, or oil, then connect the output speed sensor connector (A) securely.

Fig 2: Identifying Output Speed Sensor Connector
Courtesy of KIA MOTORS AMERICA, INC.
Installation is the reverse of removal.