Burglar Alarm Function

BURGLAR ALARM 

1. Basic Concept
   1. The following functions are related to the RKE and burglar alarm systems.
      • Door locking
      • Door unlocking
      • PSD open/close (both for left and right)
      • PTG open/close
      • Panic
   2. If IGN key is inserted into the key cylinder, the RKE transmitter functions are inoperative.
   3. Door locking by RKE signal:
      • Whenever this signal is received, door LOCK pulse is always issued.
      • Hazard lamp flashes one time for 1 second depending on the burglar alarm state.
      • This signal will make the system possible to enter into the ARM state (or PREARM state depending on the vehicle condition).
   4. Door unlocking by RKE signal.
      • Whenever this signal is received, door UNLOCK pulse is always issued.
      • Hazard lamp flashes two times whenever the key fob unlock signal is received.
      • This signal will make the system possible to enter into the DISARM or 30sec DELAY state depending on Condition A is true or not.
   5. LH or RH PSD open/close by RKE signal.
      • Only with the information received by RKE, the burglar alarm system cannot distinguish the OPEN signal from CLOSE signal.
      • RAM will pass this signal to LH PSD and RH PSD then the burglar alarm state is decided depending on the vehicle condition.
   6. PTG open/close
      • Only with the information received by RKE, the burglar alarm system cannot distinguish the OPEN signal from CLOSE signal.
      • RAM will pass this signal to PTG module then the burglar alarm state is decided depending on the vehicle condition.
   7. Panic by key fob
      • Whenever this signal is received, the PANIC function is activated (unless the system is already in an ALARM state).
   8. Mechanical key on the driver door, assist door and tail gate door
      • It is possible to ARM or DISARM the system.
2. Functional Diagram
   Fig 1: Burglar Alarm - Functional Diagram

   Courtesy of KIA MOTORS AMERICA, INC.